
A sewer hose that leaks is the worst part of camping.
Cheap hoses crack in the sun, kink when you lay them out, and drip on the ground when you disconnect. This one does not.
- βͺΒ Β Thin hoses crack and split. Dollar-store tubing gets brittle after one summer in the sun. One crack and you are dealing with a mess on the ground.
- βͺΒ Β Kinks stop the flow. A hose that bends sharply cuts the flow rate in half. You stand there longer, and the tank backs up.
- βͺΒ Β Loose fittings drip. If the adapter does not seal, you get drips on the RV bumper and the ground. Nobody wants that.
- βͺΒ Β This kit solves all three. Thick TPE hose, locking adapters, and a 90-degree elbow that keeps the flow straight. No kinks, no leaks, no mess.

The bridge between your RV and the dump station.
One end connects to the RV outlet, the other to the holding tank or sewer inlet. That is the whole job.

Long enough to reach from the RV outlet to the dump inlet or portable tank, even in tight campsites.
Flexible TPE tubing that collapses for storage and stays flexible in cold weather. No kinks, no flat spots.
Fits 3 inch, 3.5 inch and 4 inch dump outlets. One adapter covers every RV drain size on the market.
Connects to the RV outlet at a right angle so the hose runs straight down to the ground. No sharp bends.
Thick hose, locking fittings, no drips.
The hose is the product. The fittings are what make it not leak.

- βͺΒ Β Corrugated TPE construction. The hose flexes and bends without kinking. It collapses to a tight coil for storage.
- βͺΒ Β Stainless steel clamps. Four worm-gear clamps hold the hose to every fitting. They do not rust, they do not slip.
- βͺΒ Β Storage caps included. Cap both ends when not in use. Keeps smells in and dirt out.
- βͺΒ Β UV resistant. The black TPE resists sun damage. No brittleness, no cracks after a summer outdoors.
Connect, dump, disconnect, cap.
It is not complicated, but there is a right order. Follow it and it stays clean.
Attach the 90-degree elbow to the RV drain outlet. Twist until it locks. Run the hose to the dump inlet or holding tank.
Connect the 3-in-1 adapter to the sewer inlet or portable tank. Make sure both ends are tight.
Open the black tank valve first, then the gray tank. Let everything drain. Rinse if needed.
Close the valves, disconnect the hose, cap both ends. Stow the hose in its storage compartment.

What it connects to, and what it does not.
It carries waste water from the RV to the dump. It is not a drinking water hose.
| Use it for | Fits | Note |
|---|---|---|
| RV black and gray tanks | Standard 3 inch, 3.5 inch and 4 inch outlets | The 3-in-1 adapter covers all common RV drain sizes. |
| Portable holding tanks | Standard tank inlet fittings | Connects to the inlet on most portable waste tanks. |
| Campground sewer inlets | Standard 4 inch sewer ports | The elbow and adapter fit most campground dump station inlets. |
| Drinking water or potable water | β | This is a waste hose. Never use it for drinking water. |
| Pressure washing or pumps | β | It is gravity flow only. Do not connect to a pump or pressure source. |
Note: Always wear gloves when handling a sewer hose. Rinse and dry the hose before long-term storage.
Three ways to handle RV waste.
Same job, and the real difference in mess and reliability.
| At a glance | This 15 ft kit | Budget hose | No hose (bucket) | Rigid pipe |
|---|---|---|---|---|
| Length | 15 ft, reaches most inlets | 10 ft, may not reach | N/A, bucket by hand | Fixed length, rigid |
| Kink resistance | Flexes without kinking | Kinks easily | N/A | No kink but bulky |
| Fittings | 3-in-1 adapter, elbow, clamps | Basic adapter, no elbow | N/A | Threaded, rigid |
| Storage | Collapses to a coil | Collapses, but stiff | Bucket stays | Bulky, hard to store |
| Best for | Campers, RVs, portable tanks | Light occasional use | Short distances | Permanent installs |
What you get, in plain numbers.
Length, material, fittings, and what is included.
| Specification | Value |
|---|---|
| Length | 15 feet (approx. 4.6 m) |
| Hose material | TPE corrugated tubing, UV resistant |
| Diameter | 3 inch (76 mm) |
| Adapter | 3-in-1 for 3, 3.5 and 4 inch outlets |
| Elbow | 90-degree black plastic |
| Clamps | Four stainless steel worm-gear clamps |
| Caps | Two storage caps included |
| Color | Black |
15 ft sewer hose, 3-in-1 adapter, 90-degree elbow, four clamps, two storage caps.
This is a waste water hose. Not for drinking water. Wear gloves when connecting and disconnecting. Rinse after each use.
Four rules that keep the hose clean and lasting.
A sewer hose is not something you want to deal with twice. A few habits make it last.
- βͺΒ Β Wear gloves. Use disposable gloves every time you connect or disconnect. Sanitize your hands after.
- βͺΒ Β Rinse after use. Flush the hose with clean water at the dump station before you roll it up.
- βͺΒ Β Store dry. Do not coil a wet hose into the storage compartment. Let it air dry first.
- βͺΒ Β Check clamps every season. If a clamp is rusted or loose, replace it before the next trip.

If your RV has a standard 3 inch, 3.5 inch or 4 inch drain outlet, yes. The 3-in-1 adapter covers all common sizes.
You can connect two hoses together with a coupler, but longer runs slow the flow. 15 feet is the recommended max.
Flush it with clean water at the dump station. You can run a little soapy water through it, then rinse again.
No. This is a waste water hose. Never use it for potable water.
With regular rinsing and proper storage, expect 3 to 5 years of seasonal use.
- βͺΒ Β 15 foot RV sewer hose kit with 3-in-1 adapter and 90-degree elbow.
- βͺΒ Β TPE corrugated hose, flexible, UV resistant, no kinks.
- βͺΒ Β Four stainless clamps and two storage caps included.
- βͺΒ Β Fits most RVs and portable holding tanks. Waste water only.
15 ft RV sewer hose kit, TPE corrugated, with adapter, elbow, clamps and caps.





Reviews
There are no reviews yet.