Tires are what connect your truck to the ground.
You bash, you jump, you land hard. The chassis survives. The tires wear out. Bald tires slip, spin out, and ruin your runs.
- βͺΒ Β Bald tires lose grip. Once the knobs wear down, the truck spins out on dirt and slides on pavement.
- βͺΒ Β Stock tires are mediocre. The tires that come with your truck are budget. They work until they do not.
- βͺΒ Β Glueing tires is a pain. Cleaning, gluing, holding, waiting. It takes an afternoon.
- βͺΒ Β Pre-glued tires skip all of that. They arrive mounted on wheels, glued, balanced. Pop them on, run them.
Four tires, pre-glued, ready to bolt on.
No glue, no mess, no waiting. Just bolt on and run.
Knobby tread pattern that grips dirt, grass, and pavement. The standard for RC bashing.
The tires are glued to the nylon wheels at the factory. No glue required from you.
Durable nylon wheels that flex on impact. Do not crack on hard landings.
Two front and two rear. Everything you need to replace all four tires at once.
The tread is what matters.
Cheap tires have soft rubber that wears in two runs. These are harder and last.
- βͺΒ Β Knobby tread pattern. Large knobs dig into dirt and grass. Smaller knobs grip pavement.
- βͺΒ Β Durable rubber compound. Harder rubber that lasts longer than soft stock tires.
- βͺΒ Β Pre-glued bead. The tire bead is glued to the wheel with industrial adhesive.
- βͺΒ Β Foam inserts included. Each tire has a foam inner liner to keep its shape.
Bolt on. Four steps.
No special tools beyond the wrench you already have.
Loosen the wheel nuts with a 7mm nut driver. Pull the old wheels off.
Make sure the hex adapter on the axle matches the wheel hex. Check before bolting on.
Line up the hex, push the wheel on, hand-tighten the nuts.
Tighten the nuts with the nut driver. Give them a firm twist. Go bash.
Fits most 1/8 4WD short course trucks.
Check your hex size before ordering. These fit 17mm hex adapters.
| Specification | Value |
|---|---|
| Scale | 1/8 |
| Type | Short course truck |
| Quantity | 4 tires and wheels |
| Hex size | 17mm |
| Tire diameter | Approx. 108 mm (4.25 in) |
| Tire width | Approx. 42 mm (1.65 in) |
| Wheel material | Nylon |
| Tread | All-terrain knobby |
Note: Fits 1/8 4WD short course trucks with 17mm hex. Measure your hex before ordering.
Three ways to handle worn tires.
Same bald tire, three options.
| At a glance | Pre-glued set | Glue your own | Buy stock tires | Run bald |
|---|---|---|---|---|
| Cost | $50 to $70 | $30 in supplies | $60 to $80 | $0 |
| Time | 10 minutes | Afternoon | 10 minutes | 0 |
| Durability | Good | Good if done right | Mediocre | Getting worse |
| Grip | All-terrain | Depends on glue | Good | Poor |
| Best for | Quick refresh | Hobbyists | OEM replacement | Temporary |
What you get, in plain numbers.
Material, size, and what is in the package.
| Specification | Value |
|---|---|
| Product | 1/8 RC short course tire and wheel set |
| Color | Black tires, black wheels |
| Material | Rubber tires, nylon wheels |
| Glue | Pre-glued |
| Foam inserts | Included |
| Hex | 17mm |
| Quantity | 4 pieces |
| Fit | 1/8 4WD short course trucks |
4 pre-glued RC tires and wheels. Wheel nuts not included. Truck not included.
Check your hex size. These fit 17mm hex. If your truck uses a different hex, you may need adapters.
Four rules that keep tires gripping.
RC tires are consumables, but a few habits extend their life.
- βͺΒ Β Clean after each run. Dirt and sand grind into the tread. Brush them off after every session.
- βͺΒ Β Check the glue after hard crashes. A big crash can break the glue bead. Check the bead after a bad landing.
- βͺΒ Β Do not run on rough concrete. Concrete with exposed aggregate chews through tires in minutes. Stick to dirt or smooth pavement.
- βͺΒ Β Rotate front to back. Swap front and rear tires every few runs. They wear evenly and last longer.
They fit most 1/8 4WD short course trucks with 17mm hex. Measure your hex before ordering.
No. They are pre-glued at the factory. Bolt them on and run.
On dirt, about 20 to 30 runs before the knobs wear down. On pavement, less.
Yes. When the tires wear out, you can peel off the old rubber and glue new tires on these wheels.
Yes. Each tire has a foam inner liner already inside.
- βͺΒ Β 1/8 scale RC short course tires, set of 4.
- βͺΒ Β Pre-glued to nylon wheels, 17mm hex.
- βͺΒ Β All-terrain knobby tread, foam inserts included.
- βͺΒ Β Bolt on and run, no glue required.
1/8 RC short course tires and wheels, pre-glued, 4 pack, 17mm hex.
Reviews
There are no reviews yet.